Risering help

From molding systems to gating, what goes on at the molding bench will make or break a casting.
mite5255
Posts: 1740
Joined: Thu Jun 02, 2011 1:11 am
Location: Caboolture Qld Australia

Re: Risering help

Post by mite5255 »

Yes please keep posting, your experience and advice is invaluable

Mike
When life gets tough, remember: You were the strongest sperm :)
bunyip
Posts: 53
Joined: Tue Jan 17, 2012 5:17 am
Location: Charam, Victoria, Australia.

Re: Risering help

Post by bunyip »

Absolutely yes !! Please keep posts coming, regardless of how trivial some posts may appear to the writer there are always readers able to make good use of information other casters may take for granted.It must be remembered that some readers are outright beginners and all information helps.Cheers everyone, Trev.
On top down under
dallen
Posts: 2321
Joined: Sat Jun 04, 2011 9:06 am
Location: Oklahoma

Re: Risering help

Post by dallen »

going to throw in with everyone else, I have learned quite a bit from reading what you have to say HT, casting is slow for me at the moment due to it being in the triple digits on the thermometer here in OK.

but hope to fire up and pour something here pretty quick.

I was able to help SVSeeker with his propeller blades man what a some pours that was 70 plus pounds of NiBrAl, so I haven't just been laying around

DA
David and Charlie aka the shop monster

If life seems normal your not going fast enough" Mario Andrette
Post Reply