Hello from OKC
Posted: Sun Apr 06, 2014 6:02 pm
Since I popped into dallens thread, I probably better say a little something about myself. I met dallen through the Alloy Avenue group and have been lurking here for a while watching DA's shaper build. I went over to his place last year to see it run. I know he has it converted to electric now, but it was quite impressive to see it running on lawnmower engine.
I have built a furnace, but only had a chance to use it once.
Like Dave, I been working on a CNC router. I am building a Mechmate. My primary project has been building an airplane, which I hope to get back onto after the router is built. May also have to do use the router to make some patterns and try to use my furnace more than I have so far.
I have built a furnace, but only had a chance to use it once.
Like Dave, I been working on a CNC router. I am building a Mechmate. My primary project has been building an airplane, which I hope to get back onto after the router is built. May also have to do use the router to make some patterns and try to use my furnace more than I have so far.