Bearings

Have something and want to be rid of it? This is for Member to Member dealing.
Post Reply
User avatar
Jammer
Posts: 1488
Joined: Thu Jun 02, 2011 4:04 pm
Location: Ohio

Bearings

Post by Jammer »

Anyone need any bearings like this? 1 1/4" McGill Camfollower bearings # CCF 1 1/4 S. I have 10 of them, been laying around a while and I'm trying to clean up some. I'll probably have some more small stuff later.
They are marked $11.00 each so how about $4 ea, shipping for all would be around $10. Les if you only need a couple.
Image
Image
quando omni flunkus moritati 8-)
User avatar
Nudge
Posts: 305
Joined: Sun Jun 05, 2011 6:18 pm
Location: Auckland, New Zealand

Re: Bearings

Post by Nudge »

Thats not a bad price, but I have no idea what I would use them for. :)
I like to build "Stuff" using Stuff that costs Stuff All!
User avatar
Harry
Site Admin
Posts: 1020
Joined: Fri Apr 16, 2010 10:15 am
Location: Onyx California
Contact:

Re: Bearings

Post by Harry »

I was thinking the same thing Nudge, Jammer is there some kind of spec on these somewhere? Did you have any ideas of what you were going to use them for?
I'd rather laugh with the sinners than cry with the saints the sinners are much more fun...
Muller
User avatar
Jammer
Posts: 1488
Joined: Thu Jun 02, 2011 4:04 pm
Location: Ohio

Re: Bearings

Post by Jammer »

There are some like this on some of the large printing equipment I have or had. They follow an offset cam to make a table or arm move. I got these with some stuff in a box from an auction. I got a bunch of t-nuts and other stuff I'm sorting through. I got a whole set of insulating washers for electric motor repair if anyone is into that.
I'll check to see what the thread size is, I think it's 1/2" Fine thread.
quando omni flunkus moritati 8-)
Post Reply