Found Dreaming

Anyone need any bearings like this? 1 1/4" McGill Camfollower bearings # CCF 1 1/4 S. I have 10 of them, been laying around a while and I'm trying to clean up some. I'll probably have some more small stuff later.
They are marked $11.00 each so how about $4 ea, shipping for all would be around $10. Les if you only need a couple.

Thats not a bad price, but I have no idea what I would use them for.

I was thinking the same thing Nudge, Jammer is there some kind of spec on these somewhere? Did you have any ideas of what you were going to use them for?

There are some like this on some of the large printing equipment I have or had. They follow an offset cam to make a table or arm move. I got these with some stuff in a box from an auction. I got a bunch of t-nuts and other stuff I'm sorting through. I got a whole set of insulating washers for electric motor repair if anyone is into that.
I'll check to see what the thread size is, I think it's 1/2" Fine thread.