Hi, I need to build a little foam cutter similar to a circular saw. The cut width should be adjustable. Does anybody have examples or links for that?
(Already tested the wire with transformer)
Foam cutter - any ideas?
- 4cylndrfury
- Posts: 140
- Joined: Thu Jun 02, 2011 10:09 am
- Location: Cincinnati, Ohio, USA
Re: Foam cutter - any ideas?
I have a few links, first, you can mount something like THIS TOOL to the bottom of a table with an adjustable fence.
But if your dead set on a hot wire table, I ALWAYS GO TO INSTRUCTABLES when Im trying to figure out how to make something.
But if your dead set on a hot wire table, I ALWAYS GO TO INSTRUCTABLES when Im trying to figure out how to make something.
"Simplicity is the ultimate sophistication"
-Leonardo Di Vinci
"The future's uncertain and the end is always near...."
-Jim Morrison
-Leonardo Di Vinci
"The future's uncertain and the end is always near...."
-Jim Morrison
Re: Foam cutter - any ideas?
Thank you very much! That´s the design I had in mind!4cylndrfury wrote:But if your dead set on a hot wire table, I ALWAYS GO TO INSTRUCTABLES when Im trying to figure out how to make something.