Page 2 of 2
Re: Helm Wheel Pattern
Posted: Wed Sep 14, 2011 6:40 pm
by HT1
Good pattern, good results
Re: Helm Wheel Pattern
Posted: Thu Sep 15, 2011 9:36 am
by 4cylndrfury
thats a great looking pattern, and Im always impressed with your how tos. I am curious tho, why dont you just sprue into the back of the hub? Are you afraid the metal will wash out the sand in the front of he hub? I was just thinking that a single sprue down to the hub, with a vent at the end of each spoke would offer less cleanup - Whenever I think about pattern making, I get hung up on the cleanup as thats where my tooling is the holdup :/
Re: Helm Wheel Pattern
Posted: Fri Sep 16, 2011 5:43 pm
by HT1
Re: Helm Wheel Pattern
Posted: Fri Sep 16, 2011 6:21 pm
by dallen
nice
Re: Helm Wheel Pattern
Posted: Sun Sep 25, 2011 7:09 pm
by Harry
Very nice HT, you are amassing quite a pattern collection just from what I have seen you posting. That will be a huge benefit to you as time passes and you can pull old patterns to do a job rather than starting from scratch.