Page 1 of 2
Mermorial Plaque
Posted: Sun May 31, 2015 1:44 am
by mite5255
Re: Mermorial Plaque
Posted: Sun May 31, 2015 5:30 am
by dallen
nice, would say go tell the council what your up to but they probably wouldn't like it cause they didn't think of it.
Re: Mermorial Plaque
Posted: Sun May 31, 2015 3:30 pm
by mite5255
dallen wrote:nice, would say go tell the council what your up to but they probably wouldn't like it cause they didn't think of it.
Yes Dave that's a fact, not only that I'd prefer to do it all anonymously anyway...The plaque is not finished quite to the standed that I normally finish plaques ether.
Re: Mermorial Plaque
Posted: Sun May 31, 2015 5:51 pm
by dallen
I won't tell anyone that your going to start running around in the middle of the night with a Hilti gun and pocket full of nails attaching plaques to bridges and such.
Great idea by the way.
Be neat to put up a wifi camera someplace close to the one you put on the tree and watch as people stop and read it.
DA
Re: Mermorial Plaque
Posted: Mon Jun 01, 2015 12:17 am
by mite5255
Yes it would Dave, especially if it was a close family member of the deceased, they would be wondering, who did this
Re: Mermorial Plaque
Posted: Mon Jun 01, 2015 6:20 am
by dallen
nice job on the plaque anyway, you make the pattern of hire it done?
DA
Re: Mermorial Plaque
Posted: Mon Jun 01, 2015 11:25 am
by mite5255
I get Foundry Joe to make them
Re: Mermorial Plaque
Posted: Mon Jun 01, 2015 12:54 pm
by dallen
I need to get one of them poly patterns for a trailer hitch for the fire and PD here where I'm at, been thinking about it, or maybe getting jammer to set me up some code and drag out the router see if I can get some use out of it.
DA
Re: Mermorial Plaque
Posted: Mon Jun 01, 2015 1:17 pm
by Jammer
There is someone in Michigan that is making plates. At least a little closer. We might be able to go together and make up a full sheet, makes it cheaper. I'll price it with FJ's wife might be cheaper from your side of the world Mike.
Never mind, Foundry Joe is in Michigan..
for some reason I thought they were in Australia.
Re: Mermorial Plaque
Posted: Mon Jun 01, 2015 1:37 pm
by Jammer
After thinking about it, I would probably make my own pattern for a "one of" plaque. For a polymer plate I would make up something that would sell multiple copies like a fireman or police plate.