Cincinnati Shaper

[dallen]

it had some bad sand tears, but they filed off, hoping to redo the parts today, I missed a couple of the holes by a couple thousands while maching then out last night.

[dallen]

third time on this little part, got a keeper this time that didn't need 30 minutes work with a file to be useable.

[Jammer]

Looks good.

[dallen]

thanks, when I get his all figured out and am not making any more changes, I'm going to see about pouring them in cast iron, just because.

[dallen]

got this far with the project that I started the other day, before I can add the slider part I need some polished rod to make the guides out of so on hold till next week. I'm not going to put the wax Reservoir on it like the one that I'm copying, I can do what they call pan lubing which works fine for the number of slugs that I need to lube. going the pan lube route just adds one extra step in the process.

I have had the patterns enlarged enough that if I want to later on I can make a sizer with the integral lube pump, will post a photo of the patterns when they arrive.

[dallen]

little home made tool I throwed together today. the cutter and locking stud were purchased, I made the shell holder and the gauge rod

[mite5255]

I need you as my neighbor Dave

[dallen]

new patterns will be in the mail today or tomorrow, then it will be back to the sizer project. other then some sanding to smooth the surface out the patterns are ready for molding when I get them.

[Jammer]

I've already threatened to move next to him. They just have too much heat and too many tornadoes.

[dallen]

last year wasn't too bad for being hot, no telling what this year will be like. And as far as it goes for tornadoes they been popping up pretty much all over the place the last few years.